Tel: 01204 702 801

Audi A6 Rear Spring Fitment

VAGBolton have invested in the specialised equipment to replace the rear coil springs on the Audi A6.

Audi A6 Rear Spring Fitment 1

The spring compressing system VAS 6274 is required for removal and installation of the coil springs on the rear axle of the Audi A6. This item of workshop equipment is also absolutely essential for repair work on the rear axle and for removal and installation of the fuel tank.

With the aid of thrust plates, the spring is tensioned mechanically by means of a spindle and a plunger. To do this, the T-bar, socket and counter-hold tool are required in addition. The spreader device VAS is placed in between the upper wishbone and the vehicle body to maintain the height after the coil spring has been removed.

The hydraulic tensioning device is required to preload and de tension the removed spring. The mechanically tensioned spring pack should only be detensioned when no longer installed on the vehicle using the hydraulic tensioning device.

Please Call 01204702801 to discuss further.

Audi A6 Rear Spring Fitment 2 Audi A6 Rear Spring Fitment 3 Audi A6 Rear Spring Fitment 4

BOOK AN APPOINTMENT

Initial Diagnosis at £CALL

About VAG Bolton

VAG Bolton is family run business established in 1992. We specialise in the servicing and maintenance of VAG Group Motors, such as Volkswagen, Audi, SEAT and Skoda. We are conveniently based in Kearsley, Bolton which is close to the M60, M61, M62 and M66 motorways.



  • Factory trained technicians
  • Recovery service available
  • Genuine Approved VAG Parts
  • Free valet included with servicing
  • Secure workshops
  • 6 ramp workshop
  • Fully Insured
  • Highly rated